Google
 

Wednesday, March 12, 2008

6mm shank fly cutter



I need a fly cutter to flatten my milling table. A 6mm shank fly cutter that fits my Proxxon spindle is nowhere to found anywhere that I've look. Not even on ebay! Since then, a custom made 6mm shank fly cutter is the solution. It's made from a mild steel stock and hardened.

My Proxxon Spindle motor is also suffering from thermal shutdown. After some checking, I suspected the power transformer is too small for a 250W motor. I traced the circuit board and below is the schematic. I would appreciate is any of the readers can highlight any error on the schematic.


No comments: